During the processing of the duct, the TDF flange machine may be faulty and the whole process is interrupted. At this time, the machine should be shut down for repair. There are many reasons for problems with flange machines, such as internal hardware aging and personnel errors.
If there is a problem with the mechanical hardware, we need to clearly determine which part of the accessory is defective, and we will directly exchange for the new hardware device. There may also be system problems, such as system problems, which are more difficult to deal with. For better detection methods, they can be processed by conventional electrician detectors, and different solutions can be solved for different problems.
When TDF flange machine system fails, the conventional flange machine electrical testing instrument, tool, flange circuit system circuit diagram and machine circuit diagram are used to determine the fault voltage, power supply, pulse signal, etc. If the input voltage of the power supply exceeds the limit, the power supply monitor can use the voltage meter to measure the network voltage, or use the voltage tester to monitor in real-time to eliminate other causes. If there is a fault in the position control loop of the common plate flange machine, the oscilloscope can be used to check the signal state of the measuring circuit or use the flange machine oscilloscope to observe whether the signal output is out of phase or not. In order to be able to operate, the manufacturer also needs a safe quality test run for production.
The TDF flange forming machine and shearing machine, beading machine, and folding machine and other mechanical processing equipment together form a simple automatic air duct production line. The TDF flange forming machine is selected by most small-scale manufacturers to satisfy their needs. The production needs are also due to its characteristics: the machine structure is rigorous, the performance is stable and reliable, helping customers save a lot of resources and improve production efficiency.